![]() ![]() Point to the VLAN for which you want to set up IP filtering and click the pencil icon at the right of the page.At the top right of the page, click Settings.Select the network location for which you want to set up MAC authentication.To set up IP address filtering for an existing VLAN in the Insight Cloud Portal: Tap the slider next to Enable IP Authentication so that the slider background displays green.Select the check box for each device that you want to remove from the list and tap Remove Devices.Tap the down arrow next to Denied Devices or Allowed Devices. ![]() Select the appropriate check boxes for Allow access from this device and Allow access to this device.To enter a single IP address, clear the check box next to Add a range of devices.To enter a range of IP addresses, make sure that the check box next to Add a range of devices is selected, then enter an IP Mask.To add an IP address or IP address range manually:.To add currently connected devices to your allow or deny policy, tap Add Devices and select the check box next to any device, then tap Add.Under Policy, select Deny (blacklist) or Allow (whitelist).Tap Wired Settings > VLAN > IP Filtering.If you set up more than one Insight network location, at the top of the page, select the network for which you want to set up MAC authentication.Tap Networks at the bottom of the screen.To set up IP address filtering for an existing VLAN in the NETGEAR Insight mobile app: If you set up a list with allowed devices, no matter how you add devices, be sure that you add the IP address of the device that you are using to configure the VLAN, or you will lose access to the VLAN after you enable IP filtering. If you specify IP addresses that are allowed, all other IP addresses are blocked.įor information about setting up a VLAN, see How do I set up a custom VLAN in Insight?. If you specify IP addresses that are blocked, all other IP addresses are allowed. You cannot specify both blocking and allowing. For each VLAN, you can specify IP addresses or address ranges that are either blocked from accessing the switch or allowed to access the switch. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |